1. Before starting, please check all parts of the mechanical system carefully and make sure they are in good condition before starting.

2.在开始之前，必须将搅拌棒置于“中性”位置。

2. Before starting, the mixing bar must be placed in the "neutral" position.

3.启动后，必须将搅拌棒置于“卸载”位置，并排掉缸内的水。

3. After starting, the mixing rod must be placed in the "unloading" position and the water in the cylinder must be drained.

4.充电时，必须将搅拌棒置于“装载”位置。

4. When charging, the mixing rod must be placed in the "loading" position.

5.运输之前，必须将卸料斜槽固定在“驱动”位置，以防止晃动。

5. Before transportation, the discharge chute must be fixed in the "drive" position to prevent shaking.

6.操作操纵杆时，在“空档”位置稍停，然后移下一个位置。

6. When operating the control lever, stop in the "neutral" position for a while, and then move to the next position.

7.抓好文明建设，桶内多余的材料不得倒塌。卸下后，您需要清洁搅拌桶，斜槽，惰轮等。

7. Pay attention to the civilization construction, and the surplus materials in the barrel shall not collapse. After unloading, you need to clean the mixing drum, chute, idler, etc.

8.一旦有人进入气瓶以取下车门，就必须关闭车辆，拔出电动门钥匙，并监控气瓶的外部。

8. Once someone enters the cylinder to remove the door, the vehicle must be shut down, the key of the electric door must be removed, and the outside of the cylinder must be monitored.

如何降低流动搅拌车上料一体车的噪音

How to reduce the noise of mobile mixer

1.如果滤芯堵塞并且吸油困难或不足，请清洁或更换滤芯。

1. If the filter element is blocked and the oil absorption is difficult or insufficient, please clean or replace the filter element.

2.更换低粘度液压油，因为该液压油不合适或油的粘度太高。

2. Replace the low viscosity hydraulic oil, because the hydraulic oil is not suitable or the viscosity of the oil is too high.

3.燃油箱中的液位过低，油位空气被吸入泵中，并添加了相同数量的液压油。

3. The liquid level in the fuel tank is too low, the oil level air is sucked into the pump, and the same amount of hydraulic oil is added.

4.吸入或吸入管路；请勿吸入空气，检查并拧紧。

4. Inhale or inhale pipeline; do not inhale air, check and tighten.

5.泵安装支架的刚性不足，在工作过程中会产生振动和噪音。

5. The rigidity of the pump mounting bracket is not enough, which will produce vibration and noise in the working process.

6.输入法兰与传动轴之间的连接，传动轴与取力器之间的连接角度太大或松动时会产生噪音，请检查紧固情况。

6. The connection between the input flange and the transmission shaft, the connection angle between the transmission shaft and the power take-off is too large or loose, which will produce noise. Please check the fastening condition.

7.储罐中有粘附的混凝土沉积物，需要清理铲子。

7. There is adhesive concrete deposit in the storage tank, so the shovel needs to be cleaned.

本文由水泥自动搅拌车整理发布，您是不是对这些内容有所了解了呢?更多的内容请点击：http://www.sdzkjf.cn我们会有更多精彩内容等你查看。

This article is organized and released by Zhongke concrete mixer. Do you know something about these contents? For more information, please click: http://www.sdzkjf.cn We'll have a lot more to see.