您好,欢迎光临莱州聚峰机械有限公司网站! 郑重声明 进入官网

中科搅拌车购买后需要磨合吗?

来源:http://www.sdzkjf.cn/ 日期:2021-01-11 发布人:admin
现在自上料搅拌车的市场需求量很大,很多购买搅拌车的人对新购搅拌车的保养却不是很清楚,自上料搅拌车的保养还是很重要的,细致的保养能够有效的延长搅拌车的使用寿命。发动机在自上料搅拌车上起着举足轻重的作用,搅拌车整车的动力之源全靠发动机,所以我们着重的说一下搅拌车发动机的保养。
Now the market demand of self feeding mixer is very large, many people who buy mixer are not very clear about the maintenance of newly purchased mixer. The maintenance of self feeding mixer is still very important. Careful maintenance can effectively extend the service life of mixer. The engine plays an important role in the self feeding mixer. The power source of the mixer depends on the engine, so we focus on the maintenance of the mixer engine.
是磨合,新车都是有磨合期的,磨合是延长自上料搅拌车使用寿命的基础,一定要按说明书上的规定进行磨合。油净、水净、气净和机体净。柴油是搅拌车发动机的主要燃料,如果柴油不纯净,会使精密的配合机体磨合,配合间隙增大,造成漏油,滴油,供油压力降低,间隙变大,甚造成油路堵塞,抱轴烧瓦等严重故障。
The first is running in. All new cars have a running in period. Running in is the basis for extending the service life of self loading mixer. It must be run in according to the instructions. Oil purification, water purification, gas purification and body purification. Diesel is the main fuel of the mixer engine. If the diesel is not pure, it will make the precise matching body run in, increase the matching clearance, cause oil leakage, oil dripping, reduce the fuel supply pressure, increase the clearance, and even cause serious faults such as oil blockage, axle burning and so on.
若空气中含有大量尘土,将会加速缸套、活塞和活塞环的磨损。若冷却水不纯净,会使冷却系水垢堵塞后,妨碍发动机散热,润滑条件也差,机体磨损严重。若机体外表不干净,会使表面受到腐蚀,缩短使用寿命。柴油和空气中供应不及时或中断,就会出现启动困难,燃烧不良,功率下降,发动机不能正常运转等现象。若冷却水供应不足就会使机温过高,功率下降磨损加剧,降低使用寿命。
If there is a lot of dust in the air, it will accelerate the wear of cylinder liner, piston and piston ring. If the cooling water is not pure, it will block the scale of the cooling system, hinder the engine heat dissipation, poor lubrication conditions and serious wear of the engine body. If the body surface is not clean, the surface will be corroded and the service life will be shortened. If the supply of diesel and air is not timely or interrupted, it will be difficult to start, poor combustion, power decline, engine can not run normally and so on. If the cooling water supply is insufficient, the temperature of the machine will be too high, the power will be reduced, the wear will be intensified, and the service life will be reduced.
水泥自动搅拌车
经常检查紧固部位
Check the fastening parts frequently
水泥自动搅拌车。因柴油机使用的过程中受震动冲击和负荷不均匀等影响,螺栓,螺母容易松动。还有各部位的调整螺栓都要检查,以免造成因松动而损坏机体的事故。
Self feeding mixer. Due to the impact of vibration and uneven load during the use of diesel engine, bolts and nuts are easy to loosen. There are all parts of the adjustment bolts to check, so as not to cause loose and damage to the body accident.
检查调整
Check and adjust
柴油机的气门间隙、配气相位、共有提前角、喷油压力以及点火正时等都应及时检查并调整,以保证发动机经常处于良好的技术状态,方能节省燃油,延长使用寿命。
The valve clearance, valve timing, common advance angle, injection pressure and ignition timing of diesel engine should be checked and adjusted in time to ensure that the engine is always in good technical condition, so as to save fuel and prolong service life.
正确使用发动机
Correct use of engine
自上料搅拌车行驶前,应使各瓦轴等润滑部位得到润滑。启动后应待水温达到40℃-50℃时再投入到作业,严禁长时间超负荷或低速作业。停机前,应先卸掉负荷降低转速。
Before the feeding mixer runs, the bearing shaft and other lubrication parts should be lubricated. After start-up, it should be put into operation when the water temperature reaches 40 ℃ - 50 ℃. Long time overload or low speed operation is strictly prohibited. Before shutdown, the load should be removed to reduce the speed.
本文来自:水泥自动搅拌车更多的内容请点击:http://www.sdzkjf.cn我们将会为您提问的问题提供一个满意的服务,欢迎您的来电!
This article is from: Zhongke mixer. For more information, please click: http://www.sdzkjf.cn We will provide a satisfactory service for your questions, welcome your call!

上一篇:操作混凝土自动搅拌车应该做哪些细节问题?
下一篇:搅拌车施工中常见的问题介绍