您好,欢迎光临莱州中科聚峰机械有限公司官方网站! 郑重声明 进入官网

3.8方自上料水泥搅拌车要注意哪些保养事项?

来源:http://www.sdzkjf.cn/ 日期:2021-06-15 发布人:admin
1、轮胎的检查
1. Tire inspection
每月应在常温下检查一下轮胎气压,如果低于正常标准应及时补充轮胎气压。气压不能过高或过低,否则影响驾驶的安全性。检查轮胎的龟裂情况,存在安全隐患时应及时更换轮胎。选用轮胎时,应使之型号一致
Check the tire pressure at room temperature every month. If it is lower than the normal standard, replenish the tire pressure in time. The air pressure should not be too high or too low, otherwise the driving safety will be affected. Check the crack condition of the tire, and replace the tire in time when there are potential safety hazards. When selecting tires, they should be of the same type
2、发动机冷却液液面检查
2. Engine coolant level check
自上料搅拌车发动机在热机状态时,千万不要打开散热器盖,否则可能会被溅出的冷却液或高温蒸气烫伤。等发动机冷却后,检查冷却液的液面应处于满位和低位之间,否则应加蒸馏水或纯净水或冷冻液,加水后的液面高度不能超过满位。如发现短时间内冷却液减少的很快,应检查冷却系统是否有泄漏或到维修站去检查。
Never open the radiator cap when the self feeding mixer engine is hot, otherwise it may be scalded by the splashed coolant or high temperature steam. After the engine is cooled, check that the liquid level of the coolant should be between the full level and the low level, otherwise, add distilled water or purified water or refrigerant, and the liquid level height after adding water should not exceed the full level. If it is found that the coolant decreases rapidly in a short time, check the cooling system for leakage or go to the maintenance station for inspection.
水泥自上料搅拌车
3、离合器总泵液面的检查
3. Inspection of clutch master cylinder liquid level
离合器液面介于高、低液面间则表示正常,如果低于标准线,则可能是总泵或分泵皮碗损坏。在发动机运行状态下将出现挂档难或无法挂档的现象,请即时到就近的维修站检修。
If the clutch liquid level is between high and low, it means normal. If it is lower than the standard line, it may be that the master cylinder or the slave cylinder cup is damaged. When the engine is running, it will be difficult or impossible to shift. Please go to the nearest maintenance station immediately for maintenance.
4、蓄电池的保养检查
4. Battery maintenance and inspection
检查蓄电池固定是否牢固,电解液应在上限和下限之间,接近下线时应及时补加电解液或蒸馏水至高位线。保持蓄电池正负电缆接触良好,并保持蓄电池清洁干燥。放置时间较长的自上料搅拌车要摘下蓄电池的正负极电缆,相隔半个月左右重新接线起动发动机约20分钟后,如果电量明显不足要及时充电。
Check whether the battery is fixed firmly. The electrolyte should be between the upper limit and the lower limit. When it is close to the end of the line, the electrolyte or distilled water should be added to the high level line in time. Keep the positive and negative cables of the battery in good contact, and keep the battery clean and dry. Take off the positive and negative cables of the battery for the self charging mixer that has been placed for a long time, and rewire the battery after about half a month. After starting the engine for about 20 minutes, if the power is obviously insufficient, charge it in time.
5、制动液面的检查
5. Inspection of brake fluid level
制动也在高、低位之间则表示正常。如果自上料搅拌车制动液接近下限或低于下限则,表示系统中可能有泄漏或制动蹄片磨损过多,应及时到维修站进行检修。补加制动液时,要注意加同一种型号的制动液,防止损坏皮碗,注意保护好油漆防止腐蚀漆面。
If the brake is also between high and low position, it means normal. If the brake fluid of the self feeding mixer is close to or lower than the lower limit, it indicates that there may be leakage in the system or excessive wear of the brake shoes. It is necessary to go to the maintenance station in time for maintenance. When adding brake fluid, pay attention to add the same type of brake fluid to prevent damage to the leather cup, and pay attention to protect the paint to prevent corrosion of the paint surface.

上一篇:混凝土凝固在车里是怎么回事?
下一篇:保障水泥自上料搅拌车安全使用方式