您好,欢迎光临莱州中科聚峰机械有限公司官方网站! 郑重声明 进入官网

自动上料搅拌车系统气压力不足是怎么回事?

来源:http://www.sdzkjf.cn/ 日期:2021-12-30 发布人:admin
1、如果说自上料搅拌车液压泵有油液输出的情况发生,我们可以及时查看它的工作是不是正常。如果不正常,有可能是压力油路中的某个设备配件其他原因被卡住,处于回油的地方,导致压力油路和溢流回路短路的情况发生,也或许是管接头有松动的情况发生,当我们处在油路中的某些设备漏油严重,或液压缸、液压马达的密封被损坏。排除的办法就是直接拆开有关设备来清洗,看看对应的设备是不是损坏了,该更换就换,该检查就查看一下。
1. If there is oil output from the hydraulic pump of the loading mixer truck, we can check whether it works normally in time. If it is not normal, it may be that some equipment accessories in the pressure oil circuit are stuck for other reasons and are at the place of oil return, resulting in short circuit of pressure oil circuit and overflow circuit, or loose pipe joints. When some equipment in the oil circuit leaks seriously, or the seals of hydraulic cylinder and hydraulic motor are damaged. The solution is to directly disassemble the relevant equipment for cleaning to see if the corresponding equipment is damaged. Replace it when it's time to replace it and check it when it's time to check.
2、看自上料搅拌车液压泵是不是能输出液压油呢。如果说是新的液压泵,没有液压油,可能是泵体有缺陷,让吸油腔和压油腔有相通的情况发生,失去压油能力,应及时找鲁樽机械厂家更换。若不是新的液压泵,无液压油输出,则可能是泵的转向不对,零件磨损严重或损坏,及时更换。
2. See if the hydraulic pump of the self loading mixer can output hydraulic oil. If it is a new hydraulic pump without hydraulic oil, it may be that the pump body is defective, so that the oil suction chamber and oil pressure chamber are connected. If the oil pressure capacity is lost, it should be replaced by Lu Zun machinery manufacturer in time. If it is not a new hydraulic pump and there is no hydraulic oil output, the steering of the pump may be wrong, and the parts may be seriously worn or damaged. Replace them in time.
自动上料搅拌车系统气压力不足排查办法?
Troubleshooting method for insufficient air pressure of automatic feeding mixer system?
3、混凝土搅拌车的液压系统能建立正常压力,一些管路或者液压缸中间是没有压力的,可能就是因为管路、小孔或节流阀、换向阀这些部位堵住了。所以要仔细查看检查压力有没有油液通过,找出原因,然后来排除。
自上料水泥搅拌车
3. The hydraulic system of the concrete mixer can establish normal pressure. There is no pressure in some pipelines or hydraulic cylinders. It may be because the pipelines, small holes, throttle valves and directional valves are blocked. Therefore, check carefully to see if there is oil passing through the pressure, find out the cause, and then eliminate it.
4、若混凝土搅拌车的液压泵输出流量随压力升高而显着减小,且压力达不到规定值,则是由于液压泵磨损后间隙增大所致。排除方法是测定液压泵的容积效率,就可以确定这个泵是不是能继续使用的,对磨损严重的产品,一定进行修配或更换。
4. If the output flow of the hydraulic pump of the concrete mixer decreases significantly with the increase of the pressure, and the pressure does not reach the specified value, it is due to the increase of the clearance after the hydraulic pump is worn. The elimination method is to measure the volumetric efficiency of the hydraulic pump, so as to determine whether the pump can continue to be used. The severely worn products must be repaired or replaced.

上一篇:自拌料搅拌车车辆操作要注意什么?
下一篇: 你是不是也犯过混凝土搅拌车保养错误?