您好,欢迎光临莱州聚峰机械有限公司网站! 郑重声明 进入官网

搅拌车打孔技巧以及驾驶操作

来源:http://www.sdzkjf.cn/ 日期:2022-05-30 发布人:admin
水泥自上料搅拌车的打孔技术操作起来并不难,需要按照一定的方法以及步骤来进行,这样才能没问题的进行下去,下面来讲解一番吧。
The drilling technology of cement self loading mixer is not difficult to operate. It needs to be carried out according to certain methods and steps so that it can proceed without problems. Let's explain it below.
1、在钻孔过程中,塑料渣衬很容易掉入搅拌机原有的管路中,所以在操作过程中要多加注意,否则会堵塞末端的水点;
1. During the drilling process, the plastic slag lining is easy to fall into the original pipeline of the mixer, so pay more attention during the operation, otherwise the water point at the end will be blocked;
2.不要在有孔的树枝上使用焊接工具,因为这会损坏衬里。
2. do not use welding tools on tree branches with holes, as this will damage the lining.
3、搪玻璃搅拌器内衬较软,会损坏钻头。另外,边角也不整齐。
3. The lining of glass lined agitator is soft, which will damage the drill bit. In addition, the edges and corners are not neat.
4、搅拌机打孔支管不得使用电焊(气焊)工具,因为电焊会破坏搅拌机的塑料内衬,支管连接处必须用专用管件开槽;
4. Electric welding (gas welding) tools shall not be used for the perforated branch pipe of the mixer, because electric welding will damage the plastic lining of the mixer, and the joint of the branch pipe must be slotted with special pipe fittings;
5、钻孔时残渣会落入搪玻璃搅拌机内,操作时请小心,否则会造成堵塞。
5. During drilling, the residue will fall into the glass lined mixer. Please be careful during operation, otherwise it will cause blockage.
6、虽然打孔时内衬塑料比较软,但用刚性钻头很容易强行破坏搅拌机,边角不易平整。
6. Although the plastic lining is relatively soft during drilling, it is easy to forcibly destroy the mixer with a rigid drill, and the edges and corners are not easy to level.
水泥自上料搅拌车
此外相关的驾驶操作也要遵循一定要求:
In addition, relevant safe driving operations shall also comply with certain requirements:
搅拌车驾驶员必须严格遵守有关规定。严禁超载,人货混装;严禁酒后驾驶;严禁无证驾驶或将车交于无证人员驾驶。
The mixer driver must strictly abide by relevant regulations. Overloading and mixed loading of people and goods are strictly prohibited; No driving after drinking; It is strictly prohibited to drive without a license or hand over the vehicle to a person without a license.
起动前,应检查轮胎气压、燃油、机油、冷却水、各部连接件等,确认无误后,方可起动,燃油箱必须加盖加锁。
Before starting, check the tire pressure, fuel, engine oil, cooling water, connectors of all parts, etc. before starting. The fuel tank must be covered and locked.
起动后,必须检查水泥自上料搅拌车部,特别是制动系统、转向系统、仪表、灯光、喇叭、刮水器、后视镜等部件,确认无误后,方可行驶。禁止车辆带病运行。
After starting, the cement self feeding mixer truck, especially the braking system, steering system, instruments, lights, horns, wipers, rear-view mirrors and other components, must be checked, and can only be driven after confirmation. It is forbidden to operate the vehicle with faults.
在下坡路段行驶时,禁止发动机熄火或空档行驶。上下陡坡时应预先换入低速档,避免在陡坡上换档。
When driving on a downhill road, it is forbidden to stop the engine or drive in neutral. When going up and down steep slopes, shift to low gear in advance to avoid shifting on steep slopes.
车辆停放时,发动机应熄灭,拉紧手制动,必要时用三角木楔紧车轮。
When the vehicle is parked, the engine shall be turned off, the hand brake shall be tightened, and the wheels shall be tightened with a triangular wedge if necessary.
搅拌车打孔技巧以及驾驶操作就是这样了,遵守相关规定才能更好更的施工,更多信息就来关注我们网站www.sdzkjf.cn获取吧!
This is the case with the drilling skills and safe driving operation of the mixer truck. Only by complying with the relevant regulations can the construction be better and safer. For more information, please pay attention to our website www.sdzkjf Cn get it!

上一篇:控制好平口搅拌机设备用水量的方法
下一篇:搅拌车公路行驶时发动机过热很危险赶紧应对!