您好,欢迎光临莱州聚峰机械有限公司网站! 郑重声明 进入官网

降低自动搅拌车的故障率要注意什么?

来源:http://www.sdzkjf.cn/ 日期:2023-03-22 发布人:admin
在行驶中或启动时发现自动搅拌车车轮有异常响声,要及时检查轴承及刹车系统是否有故障。如果车轮运转不正常,就会影响车速,从而使油耗加大。离合器打滑会使动员机的转速降低。当您在急加速时发现动员机转速表增加很快,但车速增加却很慢,这时可以鉴定是离合器打滑了。
If the wheels of the automatic mixer truck make abnormal noises during driving or starting, it is necessary to promptly check whether the bearings and brake system have faults. If the wheels do not operate properly, it will affect the vehicle speed and increase fuel consumption. Clutch slippage will reduce the rotational speed of the mobilization machine. When you accelerate rapidly, you notice that the speed indicator of the mobilization machine increases rapidly, but the vehicle speed increases slowly. At this time, it can be identified that the clutch is slipping.
自动搅拌车火花塞使用的时间太长,也会出现油耗加大的现象。因为火花塞损坏会使焚烧的能量下降,使搅拌车提速减慢,导致柴油耗损明显增加,只要更换火花塞就好了。
If the spark plug of an automatic mixer truck is used for too long, it can also cause increased fuel consumption. "Damage to the spark plug can reduce the energy used for incineration, slow down the speed of the mixer truck, and significantly increase diesel consumption. Simply replace the spark plug.".
当自动搅拌车的温控开关和节温器损坏时,会呈现油耗增加的现象。因为温控开关和节温器损坏会使水温低落,化油器不能正常工作,导致混凝土搅拌车雾化不良,油耗量明显增加。长时间行驶时,凡是会出现汽缸压力不符的现象,这时油耗也会明显增加。同时如果出现这种情况,那么就需要大修了。
When the temperature control switch and thermostat of an automatic mixer truck are damaged, fuel consumption will increase. Due to damage to the temperature control switch and thermostat, the water temperature will drop and the carburetor will not work properly, resulting in poor atomization of the concrete mixer truck and a significant increase in fuel consumption. When driving for a long time, there is usually a phenomenon of inconsistent cylinder pressure, at which time the fuel consumption will also significantly increase. At the same time, if this happens, then an overhaul is needed.
自动搅拌车
自动搅拌车使用中要注意的问题
Problems needing attention in the use of automatic mixer trucks
1、自动搅拌车应停入在平地上,并将铲斗平放地面。当发动机熄火后,需反复多次扳动工作装置操纵手柄,确保各液压缸处于无压休息状态。当自动搅拌车只能停在坡道上时,要将轮胎垫牢。
1. The automatic mixer truck should be parked on a flat ground and the bucket placed flat on the ground. After the engine shuts down, it is necessary to repeatedly pull the operating handle of the working device several times to ensure that each hydraulic cylinder is in a pressure free rest state. When the automatic mixer truck can only be parked on a ramp, it is necessary to pad the tires firmly.
2、自动搅拌车在停止工作后操作人员将各种手柄置于空挡或中间位置。
2. After the automatic mixer stops working, the operator places various handles in the neutral or intermediate position.
3、先取走电锁钥匙,然后关闭电源总开关,后关闭门窗。
3. First remove the electric lock key, then turn off the main power switch, and then close the doors and windows.
4、自动搅拌车严禁停在有明火或高温地区,以防轮胎受热爆炸,引起事故。
4. Automatic mixer trucks are strictly prohibited from parking in areas with open flames or high temperatures to prevent tires from exploding due to heat and causing accidents.
5、利用组合阀或储气罐对轮胎进行充气时,人不得站在自动搅拌车轮胎的正面,以防爆炸伤人。更多相关的内容就来我们网站http://www.sdzkjf.cn咨询吧!
5. When using a combination valve or air reservoir to inflate a tire, one should not stand on the front of the tire of the automatic mixer to prevent explosion and injury. For more relevant content, please visit our website http://www.sdzkjf.cn Consult!

上一篇:搅拌车的空调滤清器使用注意事项
下一篇:自动搅拌车的一些维护保养内容