The radiator of the engine is a very important component of the automatic loading mixer. Let's talk about the use and maintenance of radiators.

1.软化后，建议使用软水和硬水，以防止内部堵塞和水垢形成。

1. After softening, it is recommended to use soft water and hard water to prevent internal blockage and scale formation.

2.安装散热器时，请勿损坏散热器（切片）和保险杠散热器。这确保了散热和密封。

2. When installing radiator, do not damage radiator (slice) and bumper radiator. This ensures heat dissipation and sealing.

3.使用防冻液时，请使用常规厂家生产的长期防锈防冻液，并符合标准，避免散热器腐蚀。

3. When using antifreeze, please use the long-term anti rust antifreeze produced by conventional manufacturers and comply with national standards to avoid radiator corrosion.

4.备用散热器的有效环境必须保持通风和干燥。

4. The effective environment of the standby radiator must be kept ventilated and dry.

5.日常使用时，应经常检查水位，冷却后停水。加水时，慢慢打开水箱盖。保持操作员的身体尽可能远离进水口，以防止高压蒸汽和灼伤。

5. In daily use, the water level should be checked frequently and the water should be stopped after cooling. When adding water, slowly open the water tank cover. Keep the operator's body as far away from the water inlet as possible to prevent high pressure steam and burns.

自动搅拌车是如何使用和维护发动机的散热

How to use and maintain the heat dissipation of the engine for the automatic feeding mixer

6.自动搅拌车散热器不应接触酸，碱或其他腐蚀性物质。

6. The radiator of automatic feeding mixer shall not contact with acid, alkali or other corrosive substances.

7.水位计应每3个月或根据实际情况清洗一次。必须拆下零件并用温水和非腐蚀性清洁剂清洁。

7. The water level gauge should be cleaned every 3 months or according to the actual situation. Parts must be removed and cleaned with warm water and a non corrosive cleaner.

8.在冬季，使用水箱盖和排水开关释放所有水，以防止因长期停车和间接停车等因冻结导致的核心冻结。

8. In winter, use water tank cover and drain switch to release all water to prevent core freezing caused by freezing due to long-term shutdown and indirect shutdown.

9.根据实际情况，用户需要彻底清洁散热器1-3个月。清洁时，沿对面入口用清水冲洗。

9. According to the actual situation, the user needs to clean the radiator thoroughly for 1-3 months. When cleaning, rinse with water along the opposite entrance.

10.当散热器完全排空并充满时，关闭发动机缸体上的排水开关。当水流出时，再次关闭以防止起泡。

10. When the radiator is completely drained and full, first turn off the drain switch on the engine block. When water flows out, close again to prevent foaming.

本文由自动搅拌车提供技术支持，更多的详细精彩内容请点击我们的网站http://www.sdzkjf.cn，我们将会全心全意为您提供满意的服务。

This article is supported by Zhongke Jufeng mixer. For more details, please click our website http://www.sdzkjf.cn We will provide you with satisfactory service wholeheartedly.